Top » Catalog » LPKF/Germany »

Call for Price!

LPKF In-House PCB Through-Hole Plating
Without Chemicals<

<b>LPKF In-House PCB Through-Hole Plating <br>Without Chemicals<

Model Available: LPKF ProConduct®

The LPKF ProConduct® introduces revolutionary technology to produce plated through-holes, which does not require a plating tank or potentially hazardous processing chemicals. This compact system is extremely fast and easy to use. Its rapid parallel processing method delivers completely safe, reliable and thermally stable via plating results for double-sided or multilayer boards.

Circuit board prototypes can be easily fabricated in-house in a single day when the LPKF ProConduct® system is combined with an LPKF ProtoMat circuit board plotter.

In-house PCB prototyping gets your designs to market faster by eliminating production delays and high costs that can occur with outside vendors. It also makes your precious design data secure by keeping it under your control.

LPKF ProConduct® uses specially-developed plating technology to rapidly plate vias as small as 0.4 mm (15 mil) up to aspect ratio of 1:4. Even smaller holes are possible under special conditions. The entire process can be completed in just a few minutes for double-sided and even multilayer boards. The electrical resistance of LPKF ProConduct® plating is extremely low with 19.2 mOhm depending on the material thickness. For more information please read the technical data.

See Multilayer for information about using through-hole plating systems to produce multilayer circuit boards.

Working Process:

LPKF ProConduct® uses a specially-developed conductive polymer paste to quickly and easily plate vias in as little as three minutes. These are the simple processing steps:

1. Mill the board, apply film and drill the holes
Mill the board layout using a LPKF ProtoMat plotter, then apply adhesive film to the entire board surface and drill the holes.

2. Apply the LPKF ProConduct® Paste
Secure the board to the vacuum table and apply LPKF ProConduct® Paste to the adhesive film with the squeegee provided. The vacuum process draws the conductive paste through the holes. The board can be flipped and paste can be applied to the opposite side to ensure that the holes are completely coated.

3. Cure the paste
Remove the film after the LPKF ProConduct® Paste is applied, then insert the board into a hot-air oven for 30 minutes to cure the paste. After the board has cooled for a few minutes it can be populated with components and tested.

For more information please visit:

http://www.lpkf.com/products/rapid-pcb-prototyping/through-hole-plating/chemical-free/index.htm
Quick Find
 
Use keywords to find the product you are looking for.
Manufacturers
Manufacturer Info
LPKF/Germany
LPKF/Germany Homepage
Other products